Recently, a new machine entered my line up – X-Files. Release by SEGA in 1997 with 1500 made, it’s the most modern machine to enter my pinball fleet. As you know by now, I’m not one to just get a machine in and play it. There’s always work to be done cleaning, fixing and tuning my machines. This one is no different and I’ll be working my way through the machine in typical fashion for a full service.
plastics
All posts tagged plastics
It’s been quite awhile since I last did any work on my Pinbot. Not really intentional, but other pinball projects / tasks came up (Counterforce, Mariner, Last Action Hero) which were more pressing. A lot of hard work went into the machine in earlier posts and it’s been a lot of fun to play. One thing has remained outstanding though – the playfield swap. Almost 2 years ago now (July 29th, 2014) a CPR gold playfield arrived, which I wanted to install into my machine. Time sure has flown and I didn’t realise how long I had put it off. Doing a playfield swap is no easy task and certainly not something to perform quickly – so it’s been easy to push the task off until later. But it will be put off no longer. I feel ready to take the task on and essentially complete my work on Pinbot. I have a new CPR reproduction plastic set waiting to go on too, along with LEDs and some coloured Titan silicon “rubbers”. This machine is going to look f*cking awesome once done. The CPR playfield looks amazing.
Well it didn’t take long. Only a few weeks into owning a machine that I didn’t plan to do any work on, and am going to strip the playfield for a solid clean. Having had a much closer inspection now, there is a lot of dust and dirt at the top of the playfield, along the ramps and on the plastics located up there too. I really want to get it into a clean state – a base line – that I can reference to know when the machine was last given a service and deep clean. Since I’ve already worked through a number of the assemblies below the playfield, I want to give the playfield itself similar attention. While I’m doing that, I can clean the individual parts on the playfield and get fresh rubber all over it. Naturally, that means I won’t be able to play it for about a week – but it’s task well worth doing.
I’ve been having a lot of fun playing my Last Action Hero since it’s arrival. I’m not sure how it rates as a game among the pinball community, but I’ve found it to be really enjoyable and it’s a welcome entry to my Pinball fleet. My previous update focused mostly on small cosmetic things but in update #2, I’m starting to look at cleaning the assemblies to get the game running at an optimal level. First thing on my radar this time is the single scoop, located on the right side of the playfield.
It’s been awhile since my last crap box purchase. I actually wasn’t keen on buying any more as I have built up a large amount of spare second hand parts that have come in handy for my pinball projects. This one however had a few very specific parts I wanted, so I couldn’t resist. At the cost of $12.50AUD, it was hard to go wrong. First up, the largest part here, was a coin door. It’s not in the best condition, but the coin entry and return face plates are in good condition and match those found on my Pinbot machine. This could be useful for parts in the future.
