Having already made good progress on my SWEP1, I was keen to keep going and complete the remaining work. It’s no good having a half clean machine, so I made the decision to take SWEP1 offline for a couple of weeks to address the remaining playfield areas and assemblies. The lower playfield area around the apron and sling shots was covered in the last update and now I need to look at the middle and upper sections of the playfield. This means taking both ramps off to get access to everything on the playfield in these areas. The only assemblies I need to look at are the pop bumpers, so most of the work is cleaning at the playfield level and getting the parts back on.