I can always tell the level of enjoyment I get working on a machine by how much it consumes my free time. Funhouse has been consuming a lot of my free time over the last few weeks which means progress has been good. So I’m back again with the third update. In this update, I’ll be focusing on the playfield area (and assemblies) in the middle stretch of the playfield. This includes the right scoop, pop bumpers and left upper flipper. There are various plastics and metal posts that will need to be removed and cleaned. There is also a ramp that runs below the playfield connecting other assemblies to the scoop which I’ll remove and clean too.
Now I feel like i’m getting back into the swing of pin updates 🙂 Progress on the Funhouse has been moving along smoothly this week, so I am keen to get another post up. For this update, I wanted to focus on the lower playfield area. In general, everything just needs a really good clean, although the sling shot plastics will be replaced. Some of the screws used on the clear posts are not correct and these will be replaced too. All up though, it’s a solid base to start with.