Funhouse – Williams (1990)

I had the goal of finishing off Funhouse in time for Christmas. I didn’t quite make it. I’ve been keeping myself busy on the repair & service over the last week and am on the final stretch. First thing to look at for this update is the coin door. It’s been on my to do list for awhile now and no more putting it off. The red and orange have long since faded from the artwork and the coin entry housing is a bit scratched up. There is also a section of the decal ripped at the lower left corner of the front panel. When dropping the machine off, the owner asked me to touch this up and possibly paint the red flags and balloons to give it a bit more colour. It’s also missing the coin return housing, which I will need to source.

Funhouse Pinball Repair
Continue Reading

Welcome to the fourth installment on the repair and service of a Williams Funhouse. With the lower and middle playfield sections completed in previous updates, this one will be focusing heavily on the upper playfield area. I want to get a few cabinet touch ups done too as they have been on my to do list for awhile. So far the machine has been coming long great and I’m looking forward to getting it all back together for some testing. The upper playfield area is quite dirty, but everything is there so a good clean should bring it up nicely.

Funhouse Pinball Repair
Continue Reading

I can always tell the level of enjoyment I get working on a machine by how much it consumes my free time. Funhouse has been consuming a lot of my free time over the last few weeks which means progress has been good. So I’m back again with the third update. In this update, I’ll be focusing on the playfield area (and assemblies) in the middle stretch of the playfield. This includes the right scoop, pop bumpers and left upper flipper. There are various plastics and metal posts that will need to be removed and cleaned. There is also a ramp that runs below the playfield connecting other assemblies to the scoop which I’ll remove and clean too.

Funhouse Pinball
Continue Reading

Now I feel like i’m getting back into the swing of pin updates 🙂 Progress on the Funhouse has been moving along smoothly this week, so I am keen to get another post up. For this update, I wanted to focus on the lower playfield area. In general, everything just needs a really good clean, although the sling shot plastics will be replaced. Some of the screws used on the clear posts are not correct and these will be replaced too. All up though, it’s a solid base to start with.

Funhouse Pinball
Continue Reading

My recent pinball updates have been infrequent, which isn’t common for me as I like to keep on top of them. Usually my updates sit around 1 -2 weeks behind my actual progress. The Sopranos machines have been coming along well and I have plenty of content to get more posts up – I’ve just been a little slack in writing. Not slack on the actually physical side though and have been going non stop on doing various pinball things for people. To help get back into the swing of regular updates again, I’ve decided to start tracking the next machine in the queue since it’s so fresh in my mind. This next machine I’m working on is one I’m extremely excited about. This time I’ll be doing a repair & service on a “Funhouse” from Williams pinball. Released at the end of 1990 and over 10,000 units made, it’s a game I’ve been really looking forward to working on since the owner mentioned it to me a few months back. As with a number of my previous write ups, this isn’t a fancy restoration, nor a basic service as it sits somewhere in between. I’ll be working my way through each assembly and playfield part on the machine, cleaning and repairing as I go. Various things will get a face lift while staying within a budget. The game is quite dirty (although I have seen much worse) but is in a mostly working state.

Funhouse Pinball
Continue Reading