Archives

All posts for the month October, 2019

With work coming to a close on Corvette, it was time to start giving some attention to the next machine in the queue. Next up is a Bram Stoker’s Dracula. The game was originally released back in 1993, with over 6800 machines made. This one has some great shots on it and plenty to do. I’ll be giving the game a full rebuild, with all assemblies to be removed, cleaned and worn parts replaced. All playfield parts will be removed, cleaned and many new parts added also. There are some additional presentation things to do on the game too, so this one is going to keep me busy. Time to get started!

Dracula Pinball Repair
Continue Reading

Time for the final update on Corvette so I can get it back to its owner. At the end of the last update, I had removed everything from the pop bumper area and cleaned the playfield. The leaves just the upper left section of the playfield to strip and clean. This section is home to the engine. It’s an interesting feature as the engine revs during game play by rocking left and right. It’s used in a few different modes and also you can use the flipper buttons before launching the ball to have the game rev the engine. Beside the engine is also the 3 ball lock. It’s normally covered by a large plastic engine piece, but I had removed that weeks ago so I get the rails and ramps off the playfield.

Corvette Pinball Repair
Continue Reading

I’ve been busy over the last few weeks, working away on giving this lovely Corvette an overhaul. That means it’s time to pause and give an update on the progress so far. In this update I’ll be starting with the apron area and touring my up the playfield with pit stops at the flippers, slings, upper flipper and middle playfield. I’ll try and squeeze in some work on the upper playfield area too. Time to get started. First up – the apron.

Corvette Pinball Repair
Continue Reading