The work on my Bally Mariner is coming to a end. Since my last update, I’ve had the chance to play quite a few games on it and the machine has been holding up really well. Mariner has been very reliable and no issues have come up. There are just a few last things to do and then I’m done. First item on the agenda for this update is sorting out the relay coil for the up post. This one spends a lot of its time energised and as such was showing strong signs of stress. A new coil was purchased to replace it.
restore
All posts tagged restore
It’s been awhile since my last update on the progress with the Mariner. Thanks mainly to my skate ramp project which took over my Christmas and New Years holiday time. With the ramp mostly done, it was time to get back to working on this machine and edge it closer to completion. For this update I wanted to look at the pricing plates on the coin door.
Following on from my previous update, it’s now time to get everything else back onto the playfield. The plastics are being cleaned and polished as I go. I started out with the sling shots and then began moving up the playfield. As part of the first pass I also reinstalled some of the clean plastic pieces towards the top of the playfield, along with the plastic around the bonus kicker. All new rubber is going on, along with new white star posts.
It’s Mariner update time again and this for this post I’ll be starting out with some small stuff and then moving onto larger, more interesting things. I’m really looking forward to getting the machine into a state where it’s read for play. That’s still a little while off yet, but I am getting there 🙂 To begin this update, I wanted to look at the two small roll over buttons in the lower third of the playfield. These two buttons control the post down feature.
With some more progress made on Mariner, it’s time to drop past with another update showing off which assemblies have been pulled apart, serviced and cleaned. First up on the list this time are the flippers. Both flippers work, which is always a nice starting point to have. Unlike other old machines I’ve worked on, the rubber here isn’t hard and cracking (same for the rest of the playfield rubbers actually). The flipper bats are still reasonably white too. So I think the machine has been looked after over the years and likely to have had some replacement parts put in along the way.
