Well it didn’t take long. Only a few weeks into owning a machine that I didn’t plan to do any work on, and am going to strip the playfield for a solid clean. Having had a much closer inspection now, there is a lot of dust and dirt at the top of the playfield, along the ramps and on the plastics located up there too. I really want to get it into a clean state – a base line – that I can reference to know when the machine was last given a service and deep clean. Since I’ve already worked through a number of the assemblies below the playfield, I want to give the playfield itself similar attention. While I’m doing that, I can clean the individual parts on the playfield and get fresh rubber all over it. Naturally, that means I won’t be able to play it for about a week – but it’s task well worth doing.
repair
All posts tagged repair
I’ve been having a lot of fun playing my Last Action Hero since it’s arrival. I’m not sure how it rates as a game among the pinball community, but I’ve found it to be really enjoyable and it’s a welcome entry to my Pinball fleet. My previous update focused mostly on small cosmetic things but in update #2, I’m starting to look at cleaning the assemblies to get the game running at an optimal level. First thing on my radar this time is the single scoop, located on the right side of the playfield.
Normally, the new machines I bring home are projects and need a thorough service before even thinking about putting some play into them. This time it’s a bit different. I purchased my first DMD game “Last Action Hero” which was released by Data East in 1993 and it’s in fully working condition. There are a couple of cosmetic issues I want/need to look at, but nothing that’s preventing the game from being played. I still plan to give the machine a going over and inspect each assembly as I like my machines running as optimally as possible. Plus I can’t help myself, I love working on them.
It’s been awhile since my last update on the progress with the Mariner. Thanks mainly to my skate ramp project which took over my Christmas and New Years holiday time. With the ramp mostly done, it was time to get back to working on this machine and edge it closer to completion. For this update I wanted to look at the pricing plates on the coin door.
With all the globes on the playfield replaced in a previous update, it was time to give the same treatment to the headbox globes. While most were still working (these will be put aside as spares), I like to swap all the globes over when I get a machine. Maybe a bit of overkill, but I at least then know how old they are. Same goes for the rubbers, ball and batteries (not required here obviously). First step was to get the backglass out. Inside the top panel of the headbox are two metal leavers which you pull out – this then allows the backglass to be lifted.
