restore

All posts tagged restore

The Apollo 13 overhaul has continued over the last couple of weeks. Sometimes progress can feel like slow going, but it’s surprising how quickly time gets sucked up as you work through sections of a machine. Plus, it’s getting cold at night time, so working on games once the sun has gone down is getting tougher. The previous update was heavily focused on the apron area of the playfield. Shifting my attention 30cm higher up the playfield, this update will be focusing on the next lot of assemblies – so things like the flippers, up post (ball save), ball return VUK and sling shots. Technically the VUK lives under the apron area, but i’ll ignore that fact for the sake of including it in this update instead of the last one 🙂 I also want to get the CPU controlled lamps switched over to LED’s as the kit arrived. So let’s get started and begin removing some parts!

Apollo 13 Pinball Repair
Continue Reading

After the initial hold up (and frustration) with the board issues on Dr Who, progress has been moving along smoothly. Aside from that slow start, the game has been enjoyable to work on. In this update I’ll be focusing on the middle section of the playfield. In terms of assemblies, this area has the Tardis ball popper on the right, with the left side home to the upper flipper and trap door assemblies. The popper was mentioned in a previous update as I had to replace the optics which had been cut out. This time I’ll be removing the whole assembly for a service. As usual, all plastics, targets and posts will be removed for cleaning and the playfield will also receive a clean. I’ll need to remove the ramps for this part, and won’t be putting them back on until the end. Time to get started and I’ll begin with the right side.

Dr Who Pinball Repair
Continue Reading

With my holidays just about over, I was keen to complete the last steps of the new side art for X-Files and have the game back online before I returned to work. In the last update, the big tasks were done and it was now a matter of getting everything back onto the cabinet and have the game running. With the cabinet still inside, I installed the side rails, headbox support brackets and buttons next.

X Files Pinball Decals
Continue Reading

Just before I was finishing up the previous Bride of Pinbot post, an important parcel arrived from the USA. It contained the BoP ramp entry protector set from Cliffy! Due to the issues with the heart beat ramp, I was in some ways forced to replace the ramp (or leave the various hacks that had been put in place for it). I had no intention of putting the new ramp in until the protectors arrived – so I was glad to see these.

Bride of Pinbot Restoration
Continue Reading

Welcome to the fourth installment on the repair and service of a Williams Funhouse. With the lower and middle playfield sections completed in previous updates, this one will be focusing heavily on the upper playfield area. I want to get a few cabinet touch ups done too as they have been on my to do list for awhile. So far the machine has been coming long great and I’m looking forward to getting it all back together for some testing. The upper playfield area is quite dirty, but everything is there so a good clean should bring it up nicely.

Funhouse Pinball Repair
Continue Reading