On my to do list for awhile has been rebuilding the flippers. I only have one flipper kit at the moment, but that’s a start. I’ve decided to rebuild to upper set of flippers as these areas are the dirtiest of the two sets and also have plastics and posts that can be cleaned up and installed again. On the right hand side of the playfield we have a single outlane and a single in lane that sit behind the upper flipper. The flipper position is where normally you would expect to have a slingshot. The artwork damage isn’t as bad on this side as it was on the left (when looking at the sling shot). The condition of the plastic is unbroken and just dirty. There is another post cap missing, but I have plenty of spares to cover it.
plastics
All posts tagged plastics
The progress is going really well right now on Counterforce and these updates are coming faster than I had expected. My plan was to focus on one set of the flippers for this update, but that got pushed back so I could complete a few other things off first. In recent updates I’ve had my attention at a few sections around the playfield with sling shots and targets. This update will focus on the remaining targets and also the bonus saucer. Next update will be the flippers 🙂 The first part of the update will look at the small target and switch located above the left (upper) flipper. The plastic here is broken in two points.
Time for another update on the repair and service on my Gottlieb Counterforce. The momentum has been pretty good, although playing Pinbot is cutting into my repair time 😉 For this outing, I’ll be looking at the two sling shots and top area of the playfield. Normally my next step after the apron would be to look at the flippers. But while waiting for flipper kits to arrive, I decided to shift to the slingshots. There are two sling shots on the Counterforce playfield. The first is on the left, above the lower flipper. The second one is not directly opposite (as you’d normally expect), but a bit higher up on the playfield – across from the upper left flipper. I’ll start with the lower one first. Sitting behind the slingshot, we have an out lane and two in lanes. Like with the entire machine – it’s seen a lot of action and had much neglect. Lots of cleaning required and some damage I can’t undo. Thankfully the plastic is reasonably good and is not cracked. The green lane hoods are damaged (melted) from the bulb that sits below them and one has a few cracks on the front. I’ll try cleaning these up, but will most likey replace them.
This time I’ve got a serious pile of second hand pinball parts to sort through. Some 40kgs+ of assorted bits and pieces from various machines and manufacturers. This is actually two lots joined together truth be told. I purchased both at the same time and when I collected them, they were all tipped into the same box to bring home. So instead of somehow splitting them up and doing two write ups, I’ve decided to just do single post covering everything. There really is a lot of stuff here to get through. The total cost for the box was around $35AU, which isn’t too bad considering the bulk of it all. There were some items I was specifically after but most of the content is a mystery. I can’t wait to see what’s actually in here 🙂
I’ve managed to build up a backlog of crap boxes to get through. I’ve been focusing on various projects and the spare parts boxes are a low priority. That means they have been sitting around collecting dust. I’ve stopped buying them now as I’ve got more spare parts than I know what to do with. The boxes have come in handy on recent projects, so purchasing them has been worth it. But with my shelves full, there is no need add to it. This post will cover crap box #4 which will be followed by #5 and #6 when I get to them. At a grand total of $21 for the content in this post, it makes the box the most expensive crap box to date, but there was one part here I really wanted. This box looks to have a nice mix of things in it too, so time to dig in 🙂
