bushing

All posts tagged bushing

On my to do list for awhile has been rebuilding the flippers. I only have one flipper kit at the moment, but that’s a start. I’ve decided to rebuild to upper set of flippers as these areas are the dirtiest of the two sets and also have plastics and posts that can be cleaned up and installed again. On the right hand side of the playfield we have a single outlane and a single in lane that sit behind the upper flipper. The flipper position is where normally you would expect to have a slingshot. The artwork damage isn’t as bad on this side as it was on the left (when looking at the sling shot). The condition of the plastic is unbroken and just dirty. There is another post cap missing, but I have plenty of spares to cover it.

Counterforce Pinball
Continue Reading

The shooter rod on the Fireball Classic was in pretty good condition. It still operated fine, but was in need of a good clean and service. The shooter rod is fixed to the cabinet by 2 bolts that are part of the face plate. Once removed you can just pull the shooter back away from the cabinet. I found that I needed to remove the rubber first though to get it through the cabinet hole.

Fireball classic shooter rebuild

Continue Reading