The Counterforce to do list is beginning to thin out and I’m looking forward to (hopefully) having it knocked over in the next few weeks. Although as it turns out, in this update, I do a few extra things I had originally decided not to – but it’s worth the time. First on the hit list for this update is the pop bumpers. They need a proper service. I think they are many, many years over due for one. There are two pop bumpers located on the playfield and at first glance, they have been well worn over the years. The caps have some sticky crap attached to the top of them. The decoration is wearing and there is some serious playfield wear below the (once clear) platters.
assembly
All posts tagged assembly
Time for another update on the repair and service on my Gottlieb Counterforce. The momentum has been pretty good, although playing Pinbot is cutting into my repair time 😉 For this outing, I’ll be looking at the two sling shots and top area of the playfield. Normally my next step after the apron would be to look at the flippers. But while waiting for flipper kits to arrive, I decided to shift to the slingshots. There are two sling shots on the Counterforce playfield. The first is on the left, above the lower flipper. The second one is not directly opposite (as you’d normally expect), but a bit higher up on the playfield – across from the upper left flipper. I’ll start with the lower one first. Sitting behind the slingshot, we have an out lane and two in lanes. Like with the entire machine – it’s seen a lot of action and had much neglect. Lots of cleaning required and some damage I can’t undo. Thankfully the plastic is reasonably good and is not cracked. The green lane hoods are damaged (melted) from the bulb that sits below them and one has a few cracks on the front. I’ll try cleaning these up, but will most likey replace them.
Progress on Counterforce has been good over the last few weeks and the machine has served as an excellent introduction to the System 80 platform by Gottlieb. My attention is now turning towards the playfield and the various assemblies that make up the game. I like to start working from the bottom of the playfield and progress up to the top. It helps break the overall task down into a more manageable state and also allows me to test things as I go. So first up on the playfield will be the apron and ball serve assembly. The apron and shooter cover are in reasonable condition and won’t need much more than a clean. I have the alternative score and instruction cards that were unused and can go on once complete. The shooter rod has already been removed and rebuilt (included in my last update).
I’ve managed to build up a backlog of crap boxes to get through. I’ve been focusing on various projects and the spare parts boxes are a low priority. That means they have been sitting around collecting dust. I’ve stopped buying them now as I’ve got more spare parts than I know what to do with. The boxes have come in handy on recent projects, so purchasing them has been worth it. But with my shelves full, there is no need add to it. This post will cover crap box #4 which will be followed by #5 and #6 when I get to them. At a grand total of $21 for the content in this post, it makes the box the most expensive crap box to date, but there was one part here I really wanted. This box looks to have a nice mix of things in it too, so time to dig in 🙂
It’s time to once again dive into a pile of trash pinball parts and see what sort of gems I can uncover. This lot of pinball spare parts (or crap box as it’s also termed) cost under $16AU. There wasn’t anything in the original photos that caught my eye, I just wanted more spare parts available at hand for my projects. So, let’s have a look.
