Since my SWEP1 arrived, the lightsaber Neon has been unreliable. Some days it works and others it won’t start up at all. In other cases it might finally kick in part way through a game or just stop working during a JEDI battle. It was a little random. The general work around for it was to adjust the two wires coming from the lightsaber, which would usually get it working again. At least for a day or so before it stopped again. This gave me hope it was a connection issue instead of a driver board issue. Last week the Neon completely stopped and no manner of wire adjusting would get it back on. Enough is enough – time to fix the damn thing properly. There are two probable causes – an issue on the driver board or the 12V transformer inside the lightsaber. I disconnected the power connector for the lightsaber and using my DMM, tested the voltage it was receiving. The driver board was doing it’s job properly and the correct voltage was coming in. I was fairly confident the issue was with the lightsaber, but this at least clarified it. So the lightsaber was removed for a closer inspection.