The glass and t-moulding arrived this week, allowing me to finish the project off.
Initiating photo overload 🙂
The glass and t-moulding arrived this week, allowing me to finish the project off.
Initiating photo overload 🙂
The control panels were next to be done. As with my previous projects, I decided to put a layer of acrylic over the artwork to help keep it clean and extend its lifespan. Plus I think it gives a nice finish to the control panels. As you can see with the P1 and P2 start buttons, I went with different buttons to ensure everything fit and was not overcrowded on the right.
I also extended to the top of the control panel to allow for a strip of t moulding to sit at the end (as I did with my Donkey Kong cocktail) which should give it a nice finish. Note: I still need to add the t moulding to the control panel front and sides – just waiting on it arriving. I’ve ordered both light blue and light green (Galaxian) and will see which one looks best.