I seem to have taken on too many projects of late (most outside arcade cabs), which has meant finishing my pac man cab and continuing on with the cocktail has slowed right down.
I did manage to get some time in the last week to move the cocktail forward, so here is the latest.
I turned my attention to the actual construction of the control panels. My first idea was to build it big enough to have the speaker grill on the front – just like you would see on the upright. This meant one of two things – the front of the control panel needed to be much bigger than necessary, or make the grill smaller. Neither of these two options appealed to me. The control face of the control panel is big enough as it is to support the artwork – it didn’t need to be any bigger to support a grill. Therefore, I have decided to move the grill to the lower left corner of the front and back panel. This means it will also appear on the P2 side, although it won’t have a speaker and will most likely just act as a passive vent.
Since I was not going to have the grill on the control panel, I went about drawing up measurements to ensure the buttons and wiring would fit and keep the rest of the panel compact as possible.
I have kept the white t-molding at the edge of the control face of the control panel and I wanted to have a rounded feel to the control panel edges. My first version of the control panel sides looked like this: